Gellir lawrlwytho cynnwys at ddefnydd anfasnachol, megis defnydd personol neu ar gyfer adnoddau addysgol.
Ar gyfer defnydd masnachol cysyllwch yn uniongyrchol gyda deilydd yr hawlfraint os gwelwch yn dda.
Read more about the The Creative Archive Licence.

Disgrifiad

Cynhyrchu alwminiwm; dŵr yn cael ei chwistrellu ar yr alwminiwm sy'n pasio trwy'r llinell gynhyrchu ar roleri.

Oes gennych chi wybodaeth ychwanegol am yr eitem hon? Gadewch sylwad isod

Sylwadau (2)

Martyn Leonard Alderman's profile picture
This photograph shows an aluminium slab being broken down on the 80" reversing hot break down mill. The milky emulsion is a 3% soluble oil in water mix that provided flood lubrication to cool the mill rolls and provide lubrication. In spite of the soluble oil lubrication a film of aluminium oxide would build up on the rolls as a "coating" which would peel off and cause defects in anodised strip products used for car trim ( AA 5000 series alloys) or beer barrels (AA6082 ), so a rotating wire "scratch brush" was used to strip the coating which was then filtered out of the coolant by a paper filter bed. The scratch brush is hidden behind the rectangular sheet panel visible at the top of the mill. It was supplied by Dendix International of Chepstow as a spirally wound continuous brush that avoided the need for oscillation required for segmental brushes.
Martyn Leonard Alderman's profile picture
This picture shows the slab now broken down to a 20mm thick "tandem" blank for transfer to the 3 stand warm (tandem) mill at the end of the hot mill line, after which it would be coiled for further cold rolling or possibly cut to length as plate.

Rhaid mewngofnodi i bostio sylw